Newte Screw Extractor Set, 5-Piece HSS 4341 Kit for Stripped Screws, 2-14 mm Range, Double-Ended Design with Storage Case, Gold

Transform your DIY projects with this professional-grade 5-piece screw extractor set. Crafted from premium HSS 4341 steel with a hardness rating of 63-65 HRC, these gold-finished extractors efficiently remove damaged, stripped, or broken screws ranging from 2 mm to 14 mm. The comprehensive kit includes five precisely sized extractors (#0 through #4), each featuring specialized left-hand spiral flutes for optimal grip. The dual-ended design combines a drilling tip and extraction head for a seamless two-step process. Compatible with both manual and power tools, this versatile set works on various materials including metal, wood, and plastic. Each extractor is clearly marked for easy size identification, and the set comes housed in a durable storage case for organization. The kit handles multiple screw head types including flat head, Phillips, hex, and torx. For best results, operate at low speeds in a counterclockwise direction, applying moderate pressure during both drilling and extraction phases. Remember to wear appropriate safety equipment during use. SPECS: Material: HSS steel Shaft Type: Hex Shank; Size: 0#, 1#, 2#, 3#, 4# 0) Removes screw size: 2-3mm 1) Removes screw size: 3-5mm 2) Removes screw size: 4-8mm 3) Removes screw size: 5-10mm 4) Removes screw size: 6-14mm Easily removes screw and bolt head types from flat head, Phillips, hex, torx, square, round and other stripped screws or bolts. How to Use: Step1: Make sure to use the drill side, make sure it is counterclockwise , not too fast and not too slow, but make sure you drill deep enough. When drilling, make sure to use some force (not too much force, but not too light force) against the screw. Step2: Please make sure to use the extractor (Spiral) side, make sure it is counterclockwise (that is, the direction in which the screw is screwed out), and the speed should be slow, so that the screw can be grasped. Don't go too fast. If you can't grab the screw, try the extractor (Spiral) side of the large extractor instead, no need for a new hole. TIPS: * Metal chips are produced during polishing. Remove any residue before extraction. * If the extraction thread does not bite into the screw head, switch back to the burnisher and clean more of the screw head or switch to the next larger bit size and start again at step 2. * Operating or near power tools, please wear glasses boxes and protective clothing.