Jumper Cable Clamps for Milwaukee M18 18V Battery Jumper Cables Adapter Car Jump Starter for Car Emergency Restarting Charger by Tool Battery, 8AWG 5.9FT Heavy Duty Cable

Features

• [Installation Instructions] Jumper adapter cable for Milwaukee M18 is easy to install and adjust, 1. Connect the red battery clamp of the jumper cable to the vehicle's positive terminal (+) and the black clamp to the negative terminal (-). 2. Plug the battery into the adapter and make sure it is securely locked 3. Start the vehicle 4. After successfully starting the vehicle, within 28 seconds remove the jumper cables and disconnect the vehicle battery from the tool battery.
• [Important Tips] 1. When connecting, please place the battery in a safe area on the ground, and the battery power must be kept above 50%. 2. If the first ignition fails, wait a few minutes before trying to ignite again. 3. If ignition is successful, unplug the cable within 30 seconds. 4. This jumper adapter cable does not convert or reduce voltage.
• [Voltage Range] 12-24V is applicalbe.<br> [Upgraded Clamps], Riveting Connection, more firm between clamps of this jumper adapter
• [Cable Type] 1.8M/5.92FT 8AWG Tool Battery Jumper Cable compatible with Milwaukee M18. It's good for road/workshop emergency starting charger.
• [In Packing] Jumper Adapter Cable, storage bag, work gloves, and cable tie.