Jin&Bao Garage Door Bottom Weather Stripping Rubber Seal with T-Ends 5/16 inch - Protect Your Garage from Weather, Insects, and Dust with Premium Garage Door Draft Stopper

Garage Door Bottom Weather Stripping Rubber Seal with 5/16-Inch T-End – Installation Guide Step-by-Step Installation Instructions: 1. Remove Old Seal Carefully remove any existing weather stripping or rubber seal from the bottom of your garage door. 2. Locate the T-Track Grooves Identify the grooves at the bottom of your garage door where the 5/16-inch T-ends will slide in. 3. Insert the Seal Begin at one end of the door and feed the T-ends of the new seal into the grooves. 4. Slide into Place Gently slide the seal across the length of the door until fully installed. Tip: Applying soapy water or silicone-based lubricant can ease the sliding process and reduce friction. 5. Trim and Adjust Close the garage door and inspect for any gaps. If needed, trim the excess using scissors or a utility knife and reposition to ensure a snug fit. 6. Final Check Run your hand along the bottom edge to confirm a consistent seal with no openings. Important Compatibility Notice: This seal is only compatible with 5/16-inch (≈ 8 mm) T-shaped tracks. Please measure the width and depth of the channel at the bottom of your garage door before purchase to ensure a proper fit. Restoring Seal Shape (if needed): Due to compression during shipping, the seal may arrive slightly misshapen. To restore its original form, use a heat gun or hair dryer to gently warm and reshape the rubber. Benefits of Installation: By installing this high-quality garage door seal, you’ll help block out cold drafts, dust, insects, and rain, while reducing energy costs and improving overall insulation.