Jin&Bao Garage Door Bottom Weather Stripping Rubber Seal with T-Ends 5/16" - Protect Your Garage from Weather, Insects, and Dust with Premium Garage Door Draft Stopper?20FT, Yellow?

Garage Door Bottom Weather Stripping Rubber Seal with 5/16 inch T-Ends Step-by-Step Installation Instructions: [1] Remove Old Seal: Start by removing any old weatherstripping or seal from the bottom of your garage door. [2] Identify the Grooves: Identify the grooves in your garage door track where the T-ends of the seal strip will fit. [3] Insert the Seal Strip: Starting from one end of the door, insert the T-ends of the seal strip into the grooves of the garage door track. [4] Slide the Seal Strip: Carefully slide the seal strip along the track until you reach the other end of the door. Make sure that the seal strip is aligned properly and sits flush with the track. Tip: Using soapy water or a lubricant during installation can ensure a smoother sliding process and prevent damage to the seal. [5] Adjust and Trim if Necessary: Once the seal strip is in place, close the garage door and check for any gaps or spaces. If necessary, you can adjust the position of the seal strip or trim it to size using scissors or a utility knife. [6] Test the Seal: Finally, test the seal strip by running your hand along the bottom of the door to ensure that there are no gaps or spaces. Note:Due to packaging and shipping, the seal strip may experience slight deformation. To help restore its shape, it is recommended to use a heat gun to gently soften the seal and assist in reshaping it. By following these simple steps, you can effectively protect your garage from weather, insects, and dust with the Garage Door Bottom Weather Stripping Rubber Seal with T-Ends. This durable and long-lasting rubber material can withstand extreme temperatures, heavy usage, and frequent foot traffic without cracking, tearing, or losing its shape.