DPTOOL Back Tap Spark Plug Thread Repair Tool 14mm 12mm 18mm 10mm 8mm M8 M10 M12 M14 M18 Thread Chase Tap Kit

Additional Details from the Manufacturer

This item information is coming from the manufacturer. Some of the details may vary from the Nellis Auction listing. Please check the Quality Rating and Notes for information specific to this listing

More features

• Must Have Tool for Repair Spark Plug Threads: Used to fix severely cross damaged spark plug hole thread, cleaned up the threads without leaving scraps in the bore, no need pull cylinder head, no need coil insert
• No Shavings Drop Into Engine: Used grease on the threaded, so that it will trap any metal shavings within it and pull out with the device rather than drop into the cylinder chamber, not worry about stuff going down into the engine
• Material: Made of high quality 42CrMo steel, its material is equivalent to 4140 steel, with high strength and toughness, good hardenability, no obvious tempering brittleness, high fatigue limit and multiple impact resistance after quenching and tempering, and good low-temperature impact toughness. Therefore, it is more durable hard to damage, is a nice heavy and precise tool
• Specifiction: It contains 7 tools, include 8mm, 10mm, 12mm, 14mm, 18mm back tap, detail size is: M8x1.0(4.5" length); M10x1.0(4.5" length); M12x1.25(5.27"length); M12x1.25(10.3"length); M14x1.25(5.27" length); M14x1.25(10.3" length); M18x1.5(3.4" length)
• Tips: Put it straight through the hole, expand it, back thread it 3-5x. Then reverse it in reverse, especially when it started getting tougher to turn, turning from side to side from time to time, at the same time, during the whole process, Just be sure to go slow. When u hit a hard patch, back it up a little then go forward again. After repeated operations, it is easy to remove the remaining material