DMV Versa Remover and Inserter in One Device for Scleral Contact Lenses (1 Count (Pack of 1))

Features

• DMV Versa Is Designed For Inserting And Removing Scleral Contact Lenses.
• Removal - Moisten The Suction Cup (Smaller End) Of the DMV Versa With Saline Solution, Guide It To The Eye And Place It Onto The Front Of The Scleral Contact Lens Near The Edge. Slowly Pull The Lens Away From The Eye. This Action Will Loosen The Adherence Of The Lens And The Lens Will Come Free From The Eye. After Removal, Carefully Slide The Contact Lens Sideways From The Suction Cup.
• Insertion - Place A Wet Scleral Lens Onto The Large End Of The Versa Where The Lens Will Lightly Adhere. Hold The Eye Lids Open With The Other Hand And Place The Scleral Contact Lens On The Eye. Once The Lens Had Adhered To The Eye, Withdraw The DMV Versa. The Ribs In The Cup Are Designed To Provide An Elevated Surface For The Lens To Rest On And Prevent The Lens From Sticking To The Versa. Use A Mirror For Guidance.
• Cleaning - Each Time After Using The DMV Versa Clean It With 70% Isopropyl Alcohol And Allow To Air Dry, Then Store The Device In Its Case. Plan To Replace It Every Six Months.
• Precaution: If The DMV Versa Would Accidentally Become Attached To The Eye With The Small End (Suction Cup), Slide It To The Corner Of The Eye And Remove It By Turning. If The DMV Versa Become Attached To The Eye With The Large End (Resting Pad), Merely Withdraw It From The Eye, As There Is No Suction On This End.